Command Reference MSTP Commands
The following example enables the BPDU filter function globally.
Ruijie(config)# spanning-tree portfast bpdufilter default
show spanning-tree interface
Displays the global STP configuration.
9.37 spanning-tree portfast bpduguard default
Use this command to enable the BPDU guard globally. Use the no form of this command to restore
the default setting,
spanning-tree portfast bpduguard default
no spanning-tree portfast bpduguard default
This function is disabled by default.
Global configuration mode.
Once the BPDU guard is enabled on the interface, it will enter the error-disabled status if the BPDU
message arrives at the interface. Use the show spanning-tree command to display the
configuration.
The global BPDU guard takes effect only when PortFast is enabled on a port.
The following example enables the GPDU guard globally.
Ruijie(config)# spanning-tree portfast bpduguard
default
show spanning-tree interface
Displays the global STP configuration.
To Next Page
Loading...
Need help?
General