Command Reference MSTP Commands
9.38 spanning-tree portfast default
Use this command to enable the portfast feature on all interfaces globally. Use the no form of this
command to restore the default setting.
spanning-tree portfast default
no spanning-tree portfast default
This function is disabled by default.
Global configuration mode.
The following example enables the portfast feature on all interfaces globally.
Ruijie(config)# spanning-tree portfast default
show spanning-tree interface
Displays the global STP configuration.
Use this command to restore the spanning-tree configuration to the default setting.
Global configuration mode.
The function do not have a no command.
To Next Page
Loading...
Need help?
General