Command Reference LLDP Commands
TTL multiplier, in the range from 2 to 10.
Global configuration mode.
The value of Time To Live (TLV) in LLDP packet = TTL multiplier × LLDP packet transmit interval + 1.
Therefore, the TTL of local device information on the neighbor device can be controlled by adjusting
TTL multiplier.
The following example sets TTL multiplier to 5.
Ruijie#config
Ruijie(config)#lldp hold-multiplier 5
Displays LLDP status information.
11.12 lldp location civic-location identifier
Use this command to create a common address of a device connected to the network in LLDP Civic
Address configuration mode. Use the no form of this command to delete the address.
lldp location civic-location identifier id
no lldp location civic-location identifier id
ID of a common address of a network device, in the range from 1 to 1024.
Global configuration mode
This command can be used to enter the LLDP Civic Address configuration mode.
The following example creates the Civic Address information in LLDP MED-TLV as follows: set id to
1.
Ruijie#config
Ruijie(config)#lldp location civic-location identifier 1
To Next Page
Loading...
Need help?
General