Ruijie RG-S29 Series

Command Reference LLDP Commands
Defaults
The default is txrx.
Command
Mode
Interface configuration mode
Usage Guide
Disable LLDP operating mode on the interface. The interface won't send and receive LLDP packets.
The precondition for enabling LLDP on the interface is that LLDP has been enabled globally and
LLDP operates in tx, rx or txrx mode.
Configuration
Examples
The following example sets LLDP operating mode to tx on the interface.
Ruijie#config
Ruijie(config)#interface gigabitethernet 0/1
Ruijie(config-if)#lldp mode tx
Related
Commands
Command
Description
show lldp status
Displays LLDP status information
Platform
Description
N/A
11.16 lldp network-policy profile
Use this command to create an LLDP network policy and enter the LLDP network policy configuration
mode. Use the no form of this command to delete the policy.
lldp network-policy profile profile-num
no lldp network-policy profile profile-num
Parameter
Description
Parameter
Description
profile-num
ID of an LLDP network policy, in the range from 1 to 1024.
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
This command is used to enter the LLDP network policy configuration mode. When this command is
run, the policy ID must be specified.
In LLDP network-policy mode, the { voice | voice-signaling } vlan command can be used to
configure the specific network policy.
Configuration
Examples
The following example creates an LLDP network policy whose ID is 1.
Ruijie#config
Ruijie(config)#lldp network-policy profile 1