Ruijie RG-S29 Series

Command Reference LLDP Commands
Platform
Description
N/A
11.21 lldp timer tx-interval
Use this command to set the interval of sending the LLDP packets. Use no form of this command to
restore the default setting.
lldp timer tx-interval seconds
no lldp timer tx-interval
Parameter
Description
Parameter
Description
seconds
Interval of sending the LLDP packets, in the range from 5 to 32768 in
the unit of seconds.
Defaults
The default is 30.
Command
Mode
Global configuration mode.
Usage Guide
N/A
Configuration
Examples
The following example sets the interval of sending the LLDP packets to 10 seconds.
Ruijie#config
Ruijie(config)#lldp timer tx-interval 10
Related
Commands
Command
Description
show lldp status
Displays LLDP status information.
Platform
Description
N/A
11.22 lldp tlv-enable
Use this command to configure the types of advertisable TLVs. Use the no form of this command to
restore the default setting.
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability
| inventory | location { civic-location | elin } identifier id | network-policy profile [ profile-num ] |
power-over-ethernet } }