Command Reference LLDP Commands
no lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id | protocol-vlan-id | vlan-name } | dot3-tlv { all |
link-aggregation | mac-physic | max-frame-size | power } | med-tlv { all | capability | inventory |
location { civic-location | elin } identifier id | network-policy profile [ profile-num ] |
power-over-ethernet } }
802.1 organizationally specific TLV
Port And Protocol VLAN ID TLV
VLAN ID corresponding to the specified VLAN name
802.3 organizationally specific TLV
MAC/PHY Configuration/Status TLV
LLDP-MED Capabilities TLV
Inventory management TLVs, including hardware revision TLVs, firmware
revision TLVs, software revision TLVs, serial number TLVs, manufacturer
name TLVs, model name TLVs, and asset ID TLVs.
Location Identification TLV
Common address information about the network device in location
identification TLVs.
Encapsulated emergency number
Extended Power-via-MDI TLV
By default, all TLVs other than Location Identification TLV can be advertised on the interface for
products other than S12000. For the S12000 product series, only basic TLVs and IEEE 802.1 TLVs
are advertised. To advertise IEEE 802.3 TLVs and LLDP-MED TLVs, run the lldp tlv-enable
command.
Interface configuration mode
To Next Page
Loading...
Need help?
General