Ruijie RG-S29 Series

Command Reference QinQ Commands
Related
Commands
Command
Description
show interface intf-name remark
N/A
Platform
Description
N/A
12.6 frame-tag tpid
Use this command to set the packet TPID compatible with the manufacturer TPID. Use the no or
default form of this command to restore the default setting.
frame-tag tpid tpid
no frame-tag tpid
default frame-tag tpid
Parameter
Description
Parameter
Description
tpid
Packet TPID.
Defaults
The default is 0x8100.
Command
Mode
Interface configuration mode.
Usage Guide
If the TPID value of the connected third-party device is not 0x8100 (default value) defined in
IEEE802.1Q, the TPID value on the egress used to connect to the third-party device is the TPID value
of the third-party device.
Configuration
Examples
The following example sets the packet TPID compatible with the manufacturer TPID.
Ruijie(config)# interface g0/3
Ruijie(config-if)# frame-tag tpid 0x9100
Ruijie(config-if)# end
Ruijie# show frame-tag tpid
Port tpid
------ ---------
Gi0/3 0x9100
Related
Commands
Command
Description
show frame-tag tpid
N/A
Platform
N/A