Ruijie RG-S29 Series

Command Reference QinQ Commands
Description
12.7 inner-priority-trust enable
Use this command to copy the priority of the inner tag to the outer tag of the packets on the interface.
Use the no or default form of this command to restore the default setting.
inner-priority-trust enable
no inner-priority-trust enable
default inner-priority-trust enable
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is disabled by default.
Command
Mode
Interface configuration mode.
Usage Guide
If the QoS policy is configured based on the COS value of the user's VLAN tag for the service
provider's network to which a user network connects, the user's VLAN tag priority can be copied to
the outer VLAN tag, so that the user's packets are encapsulated with the outer VLAN tag and have
the same priority as the user's VLAN tag. In this case, the user's packets can be preferentially
processed and transmitted on the service provider's network.
Configuration
Examples
The following example copies the priority of the inner tag to the outer tag of the packets on the
interface.
ruijie#configure terminal
ruijie(config)# interface gigabitEthernet 0/2
ruijie(config-if)# inner-priority-trust enable
ruijie(config-if)#end
Related
Commands
Command
Description
show inner-priority-trust
N/A
Platform
Description
N/A
12.8 l2protocol-tunnel
Use this command to set the dot1q-tunnel port to receive L2 protocol message. Use the no or default
form of this command to disable this function.