Command Reference ERPS Commands
Enter configuration commands, one per line. End with CNTL/Z.
# Enable the ERPS function globally.
Ruijie(config)# erps enable
# Enter the ERPS configuration mode
Ruijie(config)# erps raps-vlan 4093
# Enable the ERPS function for the specified ring.
Ruijie(config-erps4093)# state enable
After entering the ERPS configuration mode of
the specified ring, configure this command to
enable the ERPS protocol of this specified ring.
13.3 erps monitor link-state by oam
Use this command to configure the method of monitoring the ERPS link state.
erps monitor link-state by oam vlan vlan-id
no erps monitor link-state by oam
Indicates the VLAN that monitors link state.
By default, it adopts the directly monitoring the link physical state (up or down) rather than the oam
method.
Global configuration mode.
For the link state monitoring, use the method of directly monitoring the link physical state (up or
down), also monitor the logic state (unidirectional fault, bidirectional fault or normal) of the link by the
OAM. By default, the former is adopted. If the OAM method is used, the inefficient link state
monitoring may cause the convergence time longer when the topology changes.
The following example configures the method of monitoring the link state.
# Enter the privileged EXEC mode.
Ruijie# configure terminal
To Next Page
Loading...
