Command Reference ERPS Commands
Enter configuration commands, one per line. End with CNTL/Z.
# Configure the method of monitoring the link state.
Ruijie(config)# erps monitor link-state by oam vlan 100
Use this command to configure the R-APS VLAN of Ethernet ring.
no erps raps-vlan vlan-id
No R-APS VLAN is configured.
Global configuration mode.
The R-APS VLAN must be the VLAN that is not used on the device. Cannot set the VLAN1 to the
R-APS VLAN.
The same Ethernet ring of different devices needs the same R-APS VLAN.
If you want to transparently transmit the ERPS protocol packets on a device without the ERPS
function configured, make sure that only the two ports connected to the Ethernet ring on this device
allow the R-APSA VLAN packets corresponding to this ERPS ring passing through. Otherwise, the
other VLAN packets may enter the R-APS VLAN through the transparent transmission, causing the
shock to the ERPS ring.
# Enter the privileged EXEC mode.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
#Configure the R-APS VLAN globally.
Ruijie(config)# erps raps-vlan 4093
To Next Page
Loading...
