Ruijie RG-S29 Series

Command Reference ERPS Commands
Ruijie(config-if)# exit
# Enter the ERPS configuration mode.
Ruijie(config)# erps raps-vlan 4093
#Add the ports that participate in the ERPS protocol computing to the Ethernet ring.
Ruijie(config-erps4093)# ring-port west fastEthernet 0/1 east fastEthernet
0/2
Related
Commands
Command
Description
state enable
Enable the ERPS protocol of the specified ring
in the ERPS mode of the specified ring.
sub-ring associate raps-vlan vlan-id
Establish the association between the subring
and other Ethernet rings in the subring ERPS
configuration mode.
Platform
Description
N/A
13.7 rpl-port
Use this command to configure the RPL port and RPL owner.
rpl-port { west | east } [ rpl-owner ]
no rpl-port
Parameter
Description
Parameter
Description
west
Name of the West port.
east
Name of the East port.
Defaults
No RPL port and RPL owner are configured.
Command
Mode
EPRS configuration mode.
Usage Guide
Up to one RPL link and one RPL owner node are needed and configurable for each ring.
Configuration
Examples
The following example configures the RPL port and RPL owner.
# Enter the privileged EXEC mode.
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.