Command Reference IPv6 Commands
This function is disabled by default.
Interface configuration mode
The IPv6 function of an interface can be enabled by configuring ipv6 enable or by configuring IPv6
address for the interface.
If an IPv6 address is configured for the interface, the IPv6 function will be enabled automatically
on the interface and cannot be disabled with no ipv6 enable.
Ruijie(config-if)# ipv6 enable
Displays the related information of an interface.
Use this command to configure the IPv6 general prefix in the global configuration mode.
ipv6 general-prefix prefix-name ipv6-prefix/prefix-length
no ipv6 general-prefix prefix-name ipv6-prefix/prefix-length
The network prefix value of the general-prefix following the
format defined in RFC4291.
The length of the general prefix.
Global configuration mode.
It is convenient to number the network by using the general prefix, which defines a prefix so that many
longer specified prefixes could refer to it. These specified prefixes are updated whenever the general
prefix changes. If the network number changes, just modify the general prefix.
To Next Page
Loading...
Need help?
General