Command Reference IPv6 Commands
A general prefix could contain multiple prefixes.
These longer specified prefixes are usually used for the Ipv6 address configuration on the interface.
The following example configures manually a general prefix as my-prefix.
Ruijie(config)# ipv6 general-prefix my-prefix 2001:1111:2222::/48
ipv6 address prefix-name
sub-bits/prefix-length
Configures the interface address using the general prefix.
Displays the general prefix.
Use this command to configure the default hopcount to send unicast messages in the global
configuration mode.
Global configuration mode.
This command takes effect for the unicast messages only, not for multicast messages.
Ruijie(config)# ipv6 hop-limit 100
3.7 ipv6 icmp error-interval
Use this command to set the frequency with which ICMPv6-oversize error packets are sent. Use the
no form of this command to restore the default setting.
To Next Page
Loading...
