Ruijie RG-S29 Series

Command Reference IPv6 Commands
Defaults
The default value in RA is 0 (unspecified); the interval for retransmitting NS is 1000 milliseconds (1
second).
Command
mode
Interface configuration mode.
Usage Guide
The configured value will be advertised through RA and will be used by the device itself. It is not
recommended to set a too short interval.
Configuration
Examples
Ruijie(conifig-if)# ipv6 nd ns-interval 2000
Related
Commands
Command
Description
show ipv6 interface
Displays the interface information.
Platform
Description
N/A
3.14 ipv6 nd other-config-flag
Use this command to set “other stateful configuration” flag bit of the RA message. Use the no form of
this command to delete the flag bit.
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
The flag bit is not set by default.
Command
mode
Interface configuration mode.
Usage Guide
With this flag bit set, the flag bit of the RA message sent by the device is set. After receiving this flag
bit, the host uses the dhcpv6 to acquire the information excluding the IPv6 address for the purpose of
automatic configuration. When the managed address configuration is set, the default other
stateful configuration is also set
Configuration
Examples
Ruijie(config-if)# ipv6 nd other-config-flag
Related
Commands
Command
Description
show ipv6 interface
Displays the interface information.