Command Reference IPv6 Commands
3.12 ipv6 nd managed-config-flag
Use this command to set the “managed address configuration” flag bit of the RA message. Use the
no form of this command to restore the default setting.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Interface configuration mode.
This flag determines whether the host that receives the RA message obtains an IP address through
stateful auto configuration. If the flag is set, the host obtains an IP address through stateful auto
configuration, otherwise it does not be used.
Ruijie(config-if)# ipv6 nd managed-config-flag
Displays the interface information.
ipv6 nd other-config-flag
Sets the flag for obtaining all information except IP
address through stateful auto configuration.
Use this command to set the interval for the interface to retransmitting NS (Neighbor Solicitation). Use
the no form of this command to restore the default setting.
ipv6 nd ns-interval milliseconds
Interval for retransmitting NS in the range of 1000 to 429467295 milliseconds
To Next Page
Loading...
Need help?
General