Command Reference Basic Configuration Management Commands
been loaded when you run the write [ memory ] command.
The following example saves running-config at a specified location.
Ruijie# write
Building configuration...
[OK]
Use this command to enable and disable the zero configuration function.
Enables the zero configuration function.
Disables the zero configuration function.
The zero configuration function is disabled by default.
The zero configuration function is applicable to the ACS solution only.
The zero configuration function is applicable to standalone systems only.
With the zero configuration function, DHCP Snooping Trust is enabled only on the last two
electrical ports and all SFP ports of the device by default, regardless of whether the device
supports the MGMT port.
Enabling and disabling the zero configuration function will delete the startup configuration file of
the device and trigger device restart.
The following example enables the zero configuration function.
Ruijie# zcm enable
%% Warning: After switching mode the device will automatically restart!
% Do you want to switch to zero configuration mode? [yes/no]:y
*Sep 29 12:36:20: %ZCM-5-MODE_SWITCH: The device is reloading due to zero or
To Next Page
Loading...
Need help?
General