Command Reference DHCP Commands
4.30 ip dhcp relay information remote-id string
Use this command to set the port name for remote-id. Use the no form of this command to restore the
default setting.
ip dhcp relay information remote-id string [ portname ]
no ip dhcp relay information remote-id string
This function is disabled by default.
Global configuration mode
This command is configured on the DHCP Relay. When you configure the ip dhcp relay information
remote-id string command, the device, as the DHCP Relay, adds the option information in the
DHCP request packets.
The following example sets the port name for remote-id.
Ruijie(config)# ip dhcp relay information remote-id string port-name
The following example disables this function.
Ruijie(config)# no ip dhcp relay information remote-id string
4.31 ip dhcp relay suppression
Use this command to enable the DHCP binding globally. Use the no form of this command to disable
the DHCP binding globally and enable the DHCP relay suppression on the port.
ip dhcp relay suppression
no ip dhcp relay suppression
To Next Page
Loading...
Need help?
General