Command Reference DHCP Commands
The ip dhcp relay suppression command is disabled.
Interface configuration mode.
After executing this command, the system will not relay the DHCP request message on the interface.
The following example enables the relay suppression function on the interface 1.
Ruijie# configure terminal
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ip dhcp relay suppression
Ruijie(config-if)# exit
Ruijie(config)#
4.32 ip dhcp relay-information remote-id format
Use this command to set the custom string for remote-id on an interface. Use the no form of this
command to restore the default setting.
ip dhcp relay-information remote-id format {hex | ascii} [ string ]
no ip dhcp relay-information remote-id format {hex | ascii}
This function is disabled by default.
Interface configuration mode
This command is configured on the DHCP Relay. When you configure the ip dhcp relay-information
remote-id format command, the device, as the DHCP Relay, adds the option information in the
DHCP request packets.
To Next Page
Loading...
Need help?
General