Command Reference Network Connectivity Test Tool Commands
10 Network Connectivity Test Tool Commands
10.1 clear rping table all
Use this command to clear Rping entries.
clear rping table [all | [ping-object owner test-name] | [trace-object owner test-name]]
The following example clears all Rping entries.
Ruijie# clear rping table all
The following example clears the specified Rping entry.
Ruijie# clear rping table user ruijie
Use this command to test the connectivity of a network to locate the network connectivity problem. The
command format is as follows:
ping [ip ] [address [ length length] [ ntimes times ] [ timeout seconds ] [ data data ] [ source source ]
[ df-bit ] [validate ] [ detail ] ] [ interval millisecond ] [ out-interface interface [ next-hop next-hop ] ] ]
To Next Page
Loading...
Need help?
General