Ruijie RG-S29 Series

Command Reference Network Connectivity Test Tool Commands
Usage Guide
This command is used to display the Rping information such as numbers of test accounts and users.
Configuration
Examples
The following example displays Rping information.
Ruijie#show rping detail
Total owner number: 2
Total test number: 4
owner: user1
test name: taget_1 storage type: volatile
test name: taget_2 storage type: nonVolatile
owner: user2
test name: taget_1 storage type: permanent
test name: taget_2 storage type: readOnly
Field
Description
Total owner number
The number of users
Total test number
The number of Rping accounts
owner
Username
test name
Test name
storage type
Storage type
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
10.5 traceroute
Use this command to display all gateways passed by the test packets from the source address to the
destination address.
traceroute [ip] [address [probe number ] [ source source ] [ timeout seconds ] [ ttl minimum
maximum ] ] [ out-interface interface [ next-hop next-hop ] ] ]
Parameter
Description
Parameter
Description
address
Specifies an IPv4 address.
number
Specifies the number of probe packets to be sent (range: 1-255).
source
Specifies the source IPv4 address or the source interface. The
loopback interface address (for example: 127.0.0.1) is not allowed to
be the source address.
seconds
Specifies the timeout time (range: 1-10 seconds).