Ruijie RG-S29 Series User Manual

Command Reference OSPFv2 Commands
2.19 enable mib-binding
Use this command to bind the Management Information Base (MIB) with the specified OSPFv2
process. Use the no form of this command to restore the default setting.
enable mib-binding
no enable mib-binding
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
The MIB is bound with the OSPFv2 process with the smallest ID by default.
Command
Mode
Routing process configuration mode
Usage Guide
OSPFv2 MIB has no OSPFv2 process information, so the user operates a sole OSPFv2 process by
SNMP. By default, OSPFv2 MIB is bound with the OSPFv2 process with the smallest ID. User
operations take effect for this process.
To operate the specified OSPF process over Simple Network Management Protocol(SNMP), use this
command to bind the MIB to SNMP.
Configuration
Examples
The following example operates OSPFv2 process 100 over SNMP:
Ruijie(config)# routerospf100
Ruijie(config-router)# enable mib-binding
Related
Commands
Command
Description
show ip ospf
Displays the OSPF global configuration
information.
enable traps
Configures the OSPF TRAP function.
Platform
Description
N/A
2.20 enable traps
The OSPFv2 process supports 16 kinds of TRAP packets, which are classified into four categories.
Use this command to enable sending the specified TRAP messages. Use the no form of this
command to restore the default setting.
enable traps [ error [ IfAuthFailure | IfConfigError | IfRxBadPacket | VirtIfAuthFailure |
VirtIfConfigError | VirtIfRxBadPacket ] | lsa [ LsdbApproachOverflow | LsdbOverflow |
MaxAgeLsa | OriginateLsa ] | retransmit [ IfTxRetransmit | VirtIfTxRetransmit ] | state-change

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English