Command Reference OSPFv2 Commands
Records the detail of changes.
This function is enabled by default. Without the detail parameter, the system records the logs that the
neighbor enters or exits the full state.
Routing process configuration mode
The following example logs the neighbor state changes.
Ruijie(config)# router ospf 1
Ruijie(config-router)# log-adj-changes detail
Displays the OSPF global configuration
information.
Use this command to specify the maximum number of DD packets that can be processed (initiated or
accepted) at the same time. Use the no form of this command to restore the default setting.
Maximum number of DD packets in the range from1 to 65535
Routing process configuration mode
When a router is exchanging data with multiple neighbors, its performance will be affected. This
command is configured to limit the maximum number of DD packets that each OSPF instance can
have at the same time.
To Next Page
Loading...
Need help?
General