Ruijie RG-S29 Series

Command Reference OSPFv3 Commands
ipv6 ospf authentication
Specifies interface authentication.
area virtual-link authentication
Specifies virtual link authentication.
Platform
Description
N/A
3.2 area default-cost
Use this command to set the cost of the default route for the ABR in the stub or NSSA area. Use the
no form of this command to restore the default setting.
area area-id default-cost cost
no area area-id authentication
Parameter
Description
Parameter
Description
area-id
Area ID of the stub or NSSA area.
It can be an integer or an IPv4 prefix.
cost
Cost of the default route of the stub or NSSA area in the range from 0
to 16777215.
Defaults
The default cost is 1.
Command
Mode
Routing process configuration mode.
Usage Guide
This command can only work in the ABR connected to the stub area.
Configuration
Examples
The following example sets the cost of the default route of stub area 50 to 100.
ipv6 router ospf 1
area 50 stub
area 50 default-cost 100
Related
Commands
Command
Description
area stub
Sets a stub area.
Platform
Description
N/A
3.3 area encryption
Use this command to enable encryption authentication for an OSPFv3 area. Use the no form of this
command to restore the default setting.