Command Reference OSPFv3 Commands
area area-id encryption ipsec spi spi esp null [ md5 | sha1 ] [ 0 | 7 ] key
no area area-id encryption
Specifies an area ID.
It can be an integer or the prefix of an IPv4 address.
Specifies a security parameter index, in the range from 256 to
4294967295.
Specifies the null encryption mode.
Specifies the MD5 authentication mode.
Specifies the SHA1 authentication mode.
Indicates that a key is displayed in the plain-text format.
Indicates that a key is displayed in the cipher-text format.
Specifies an authentication key.
Encryption authentication is not performed by default.
Routing process configuration mode
RGOS supports the null encryption mode and two authentication modes: MD5 and SHA1.
If encryption authentication is configured for an OSPFv3 area, the configuration takes effect on all
interfaces (except for those of virtual links) in the area. Encryption authentication configuration on
interfaces, however, takes precedence over that of the OSPFv3 area.
The following example specifies null encryption and MD5 authentication for area 1 where OSPFv3
routing processes reside, and sets the authentication password to
aaaaaaaaaaaaaaaaaaaaaaaaaaaaa.
Ruijie(config-router)# area 1 encryption ipsec spi 300 esp null md5
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Specifies interface encryption authentication.
area virtual-link encryption
Specifies virtual link encryption authentication.
Use this command to set the range of the converged inter-area addresses. Use the no form of this
To Next Page
Loading...
Need help?
General