Command Reference OSPFv3 Commands
The following command displays the information about the OSPFv3 virtual link.
Ruijie# show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 2.2.2.2 is down
Transit area 0.0.0.1 via interface FastEthernet 1/0, instance ID 0
Local address *
Remote address 3333::1/128
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in inactive
Adjacency state Down
Starts the OSPFv3 routing process.
Configures the OSPFv3 virtual link.
Displays the OSPFv3 neighbor information.
Use this command to configure the converged route outside the OSPFv3 routing domain in the
routing process configuration mode. Use the no form of this command to restore the default setting.
summary-prefix ipv6-prefix/prefix-length [ not-advertise | [ tag number ] [ cost cost ] ]
no summary-prefix ipv6-prefix/prefix-length [ not-advertise | [ tag ] [ cost ] ]
ipv6-prefix/prefix-length
Address range of the converged route
Does not advertise the converged route to neighbors.
Absence of this parameter means to advertise.
Tag value redistributed to the OSPFv3 inner route, in the range from
0 to 4294967295.
No converged route is configured by default.
Routing process configuration mode.
When routes are redistributed by another routing process into the OSPFv3 routing process, every
route is advertised to the OSPFv3-enabled device separately in the form of external link state. If the
incoming routes are continuous addresses, the autonomous system border device can advertise only
To Next Page
Loading...
Need help?
General