Command Reference NSM Commands
Displays IPv6 routing table.
5.9 ipv6 static route-limit
Use this command to set the upper threshold of the static route. Use the no or default form of this command
to restore the default setting.
Ipv6 static route-limit number
no ipv6 static route-limit number
default ipv6 static route-limit
Upper threshold of static routes in the range from 1 to
10000.
Global configuration mode
The goal is to control the number of static routes. You can view the upper threshold of the configured
non-default static routes with the show running config command.
The following example sets the upper threshold of the ipv6 static routes to 900 and then restores the
setting to the default value.
Ruijie(config)# ipv6 static route-limit 900
Ruijie(config)# no ipv6 static route-limit
Configures the IPv6 static route.
Displays the IPv6 routing table.
5.10 ipv6 unicast-routing
Use this command to enable the IPv6 route function of the RGOS. Use the no or default form of this
To Next Page
Loading...
Need help?
General