Command Reference Line Commands
Use this command to set the login authentication timeout for the line. Use the no form of this
command to restore the default setting.
timeout login response seconds
no timeout login response
The time period during which the line waits for the user to enter any
message.
Timeout value, in the range from 1 to 300 in the unit of seconds.
The following example sets the login authentication timeout to 300 seconds for line VTY 0 5.
Ruijie(config)# line vty 0 5
Ruijie(config-line)login timeout response 300
Use this command to set the specified protocol under Line that can be used for communication. Use
the no form of this command to restore the default setting.
To Next Page
Loading...
Need help?
General