Command Reference Line Commands
transport input { all | ssh | telnet | none }
no transport input { all | ssh | telnet | none }
Allows all the protocols under Line to be used for communication
Allows only the SSH protocol under Line to be used for
communication
Allows only the Telnet protocol under Line to be used for
communication
Allows none of protocols under Line to be used for communication
all, ssh and telnet protocols are allowed.
The following example specifies that only the Telnet protocol is allowed to login in line vty 0 4.
Ruijie(config)# line vty 0 5
Ruijie(config-line)transport input ssh
Displays status information
Use this command to set the logout message. Use the no form of this command to restore the default
setting.
vacant-message [ c message c ]
Delimiter of the logout message, which is not allowed within the
message.
To Next Page
Loading...
Need help?
General