Command Reference IGMP Snooping Commands
This command lets you adjust the waiting time after receiving the query message. This command takes
effect only after the switch receives the next member join message. This command does not change the
current wait time.
The following examples sets the aging time of the routing interface that the switch learns dynamically to
100 seconds.
Ruijie(config)# ip igmp snooping query-max-response-time 100
2.22 ip igmp snooping suppression enable
Use this command to enable IGMP snooping suppression.
Use the no or default form of this command to restore the default setting.
ip igmp snooping suppression enable
no ip igmp snooping suppression enable
default ip igmp snooping suppression enable
This function is disabled by default.
Global configuration mode
When this function is enabled, IGMP Snooping only forwards the first report from a specific VLAN or
group, and suppresses the following reports to constrain traffic in the networks.
This function is only supported on IGMPv1 and IGMPv2 reports.
The following example enables IGMP snooping suppression on the device.
Ruijie(config)# ip igmp snooping suppression enable
2.23 ip igmp snooping svgl profile
Use this command to specify the multicast group address range applied in the SVGL/IVGL-SVGL mode.
Use the no or default form of this command to restore the default setting.
ip igmp snooping svgl profile profile-number
To Next Page
Loading...
Need help?
General