Configuration Guide RADIUS Commands
2.4 radius set qos cos
Use this command to set the QoS value sent by the RADIUS server as the CoS value of the interface.
Use the no form of this command to restore the default setting.
Set the QoS value sent by the RADIUS server as the DSCP value.
Global configuration mode.
This command is used to set the QoS value sent by the RADIUS server as the CoS value, and the
DSCP value by default.
The following example sets the QoS value sent by the RADIUS server as the CoS value of the
interface:
Ruijie(config)# radius set qos cos
radius vendor-specific extend
Extends RADIUS as not to differentiate the IDs
of private vendors.
Use this command to enable RADIUS to support the cui function.
Use the no form of this command to restore the default setting.
This function is disabled by default.
To Next Page
Loading...
Need help?
General