Chapter 9: Video Module, Rev. 1.2
NOTE 2: Use the Zooming and Panning/Scrolling options to ensure the corner of the image is
placed as close as possible to the top left of the Capture window.
6. Click the Apply button in the lower right hand corner of the Horizontal/Vertical Offset
section;
7. The image will automatically re-adjust.
NOTE: The “Sequence #” field under the Capture window will be red until the adjusted image is
updated for the new setting.
VDR-100G3/G3S Installation Manual 06/10/2008
9-11
To Next Page
Loading...