Chapter 11: OPERATION and ALARM UNIT TEST and USER GUIDE
11.18 Status and Alarm Messages
Listed below are the alarm codes that may appear on the OAU display:
Alarm Code Description
System Error Communication with the Record Application has been lost
Video Error Communication with the Video Module has been lost
Audio Error Communication with the Audio Module has been lost
FRM Error Communication with the Final Recording Medium has been lost
Power Fail Loss of utility power.
PCM Error Communication has been lost with the Power Control Module
Remote Error
Communication has been lost with the RSMor the USB Memory Stick
Serial Error Communication has been lost with the NMEA Module
Mic Error Communication has been lost with one of the microphones
Disk Error Failure to write data to the DMM internal hard drive
GPS Error Failure to record GPS data
Table 11-1 - Alarm Code Description
NOTE: Pressing the “Mute” button acknowledges the alarm code
and silences the alarm. The alarm message will be displayed as long as
the condition causing the alarm exists.
USB Memory Stick and RSM OAU Status Messages’
Drive Absent
Drive Present, Not
Recording
Drive Present,
Recording
Drive Error
Detected*
USB
NONE STBY REC ERR
RSM
NONE STBY Not Applicable ERR
* When an error is detected with either the USB Memory Stick and/or the RSM, the OAU will also
display a “REMOTE ERROR” alarm.
Table 11-2 - USB Memory Stick and RSM OAU Status’
VDR-100G3/G3S Installation Manual 06/10/2008
11-14
To Next Page
Loading...