Chapter 11: OPERATION and ALARM UNIT TEST and USER GUIDE
VDR-100G3/G3S Installation Manual 06/10/2008
11-15
11.19 Connecting the Client PC to the USB Memory Stick
To retrieve data from the USB Memory Stick using the client PC complete the following steps:
1. Plug the USB Memory Stick in to an available USB 2.0 port on the client PC.
2. The USB Memory Stick will be visible on the Client PC as a connected USB drive.
Note: A USB 1.1 port may also be used but it takes much longer to transfer the data than a 2.0
port.
The VDR - 100G3 Playback Application may be used to view the data. Refer to Appendix 5 –
Playback Software.
11.20 Connecting Client PC to RSM
To retrieve data from the RSM using the Client PC, complete the following steps:
1. Connect the RSM to an available USB 2.0 port on the client PC using an “A to B” USB
cable;
2. The RSM will be visible on the Client PC as a connected USB drive.
The VDR - 100G3 Playback Application may be used to view the data. Refer to Appendix 5.
To Next Page
Loading...