Rutter VDR-100G3 - A5.12 Conning Page; A5.12.1 Depth Graph

Appendix 5: Playback Software, Rev. 1.1
Note! Audio data is not available during Real Time Display mode, thus all Audio
options are disabled, including all audio options under the ‘Audio’ file menu.
A5.12 Conning Page
The Conning Page is the default information page available upon start-up. Use the VDR Config
Utility to configure VDR Playback to display information in the fields provided on this page. Refer
to Appendix2: System Configuration File for instructions on using the VDR Config Utility. The
Conning Data Tab contains the following information:
 Date – Date of playback information
 Time – Time of playback information
 Latitude – Ship’s latitude
 Longitude – Ship’s longitude
 GPS Mode – Global Positioning System: SPS, DGPS (Differential GPS), PPS, RTK (Real
Time Kinematic), FRTK (Float Real Time Kinematic), and DRM (Dead Reckoning Mode)
 Heading – Ship’s heading
 Autopilot – Indicates the presence or non-presence of a heading control system (On/Off)
 COG – Ship’s Course Over Ground
 SOG – Ship’s Speed Over Ground
 Depth – Depth of ship
 ROT – Ship’s Rate Of Turn
A5.12.1 Depth Graph
The Depth Graph provides an illustration, in meters (m), of the ship’s depth.
Figure 24 - Depth Graph
VDR-100G3/G3S Installation Manual 06/10/2008
13