Chapter 12: Final Recording Medium Setup, Rev. 1.5
5. Observe the beginning and end time (system contents) of the data set to ensure that 12
hours of data have been recorded to the FRM.
6. Select the beginning of the data set to start playback and observe that video, audio and
NMEA have been recorded and that the start time of each stream is in fact 12 hours
previous to the end time. Stop playback.
7. Select the middle of the data set to playback and observe that video, audio, and NMEA
have all been recorded.
8. Select the end of the data set to start playback and observe that video, audio and NMEA
have all been recorded for 12 hours.
9. Stop playback and exit the application.
VDR-100G3/G3S Installation Manual 10/12/2008
12 - 10
To Next Page
Loading...