Santerno Sinus Penta - Page 14

SINUS PENTA
PROGRAMMING GUIDE
14/486
Cxxx Parameters (Read Only when the drive is running and the motor is operating; R/W when the drive is in stand-
by or in Run, but the motor is stopped: see P003 in PASSWORD AND USER LEVEL MENU).
Cxxx Range
Drive representation
(integer)
Display on the display/keypad and the
RemoteDrive
(may be a decimal figure)
plus unit of measure
Default
Factory-setting of the parameter
(as represented for the drive)
Factory-setting of the parameter
(as displayed)
plus unit of measure
Level
User level (BASIC / ADVANCED / ENGINEERING)
Address
Modbus address which the parameter can be read from/written to
(integer)
Control
This optional field is displayed when a parameter is not active for all types of
motor controls (IFD / VTC / FOC)
Function Parameter description
Rxxx Parameters (Read Only when the drive is in Run; R/W when the drive is in stand-by or in Run, but the motor
is stopped: see P003 Condition required for changing C parameters in the PASSWORD AND USER LEVEL
MENU).
Rxxx Range
Drive representation
(integer)
Display on the display/keypad and the
RemoteDrive
(may be a decimal figure)
plus unit of measure
Default
Factory-setting of the parameter
(as represented for the drive)
Factory-setting of the parameter
(as displayed)
plus unit of measure
Level
User level (BASIC / ADVANCED / ENGINEERING)
Address
Modbus address which the parameter can be read from/written to
(integer)
Control
This optional field is displayed when a parameter is not active for all types of
motor controls (IFD / VTC / FOC)
Function
Parameter description
NOTE
Unlike Cxxx parameters, Rxxx parameters become active only after the drive has been
switched off and switched on again, or after resetting its control board by pressing the
RESET button for more than 5 seconds.