Santerno Sinus Penta - Navigation

PROGRAMMING GUIDE
SINUS PENTA
19/486
1.3 Navigation
Figure 2: Navigation example
INVERTER OK
M00=+0.00rpm
M02=+ 0.00 rpm
[MEA] PAR CF IDP
INVERTER OK
M00=+0.00rpm
M02=+ 0.00 rpm
MEA [PAR] CF IDP
INVERTER OK
M00=+0.00rpm
M02=+ 0.00 rpm
MEA PAR [CF] IDP
INVERTER OK
M00=+0.00rpm
M02=+ 0.00 rpm
MEA PAR CF [IDP]
MEASURE MENU
M Parameters
Cannot be changed
PARAMETERS MENU
P Pars. that can
be changed when the
motor is running
CONFIGURATION M.
C-I-R Parameters
Can be changed
when motor off
PRODUCT MENU
Language selection
and Inverter data
[MEA]
MOTOR
MEASURES
[PAR]
PASSWORD AND
ACCESS LEVEL
[CFG]
AUTO TUNE
[IDP] SINUS PENTA
Start-Up Menu
Press ENTER to start
[MEA]
PID REGULATOR
[PAR]
DISPLAY/KEYPAD
[CFG]
CONFIGURATION OF
MOTOR N. 1
[IDP]
PRODUCT
Access to
Ramps
menu
P009 Acceler.
Ramp 1
→ 10.00s
Navigation within
Ramps
menu
P010 Deceler.
Ramp 1
→ 10.00s
Access to
parameter
modification P010
P010 Deceler.
Ramp 1
→ █ 10.00s
Parameter
modification P010
P010 Deceler.
Ramp 1
→ █ 20.00s
If the ESC key is pressed to quit, the new parameter
value will be acknowledged but not saved to non-
volatile memory, and will therefore be lost at power off.
Press SAVE/ENTER to confirm parameter alteration.
SAVE
ENTER
Keypad
Pages
MENU
∧
∨
∧
∨
∧
∨
∧
∨
∧
∨
∧
∨
∧
∨
ESC
SAVE
ENTER
∧
∨
SAVE
ENTER
∨
∧
∨
∧
∨
∨
∧
∨
∧
SAVE
ENTER
ESC
ESC
SAVE
ENTER
ESC
ESC
SAVE
ENTER