Santerno Sinus Penta - Warning List

PROGRAMMING GUIDE
SINUS PENTA
473/486
58.6. Warning List
Table 138: Warning list
Warning
Alarm Message
Description
W03
SEARCHING…
The user interface is searching the data of the next page to display.
W04
DATA READ KO
Software warnings concerning data reading.
W06
HOME SAVED
The page displayed has been saved as the home page displayed at power on.
W07 DOWNLOADING
The keypad is writing to the drive the WORK zone parameters saved on its own
flash memory.
W08 UPLOADING
The keypad is reading from the drive the WORK zone parameters that will be
saved on its own flash memory.
W09 DOWNLOAD OK
Parameters were successfully downloaded (written) from the keypad to the
drive.
W11
UPLOAD OK
Parameters were successfully uploaded (read) from the drive to the keypad.
W12 UPLOAD KO
The keypad interrupted parameter upload to the drive.
Parameter reading has failed.
W13
NO DOWNLOAD
A Download procedure was queried, but no parameter is saved to the flash
memory.
W16
PLEASE WAIT…
Wait until the system completes the operation required.
W17
SAVE IMPOSSIBLE
Parameter save is not allowed.
W18
PARAMETERS LOST
The keypad interrupted parameter download to the drive. Parameter writing has
failed. As a result, not al
l parameters have been updated (parameter
inconsistency).
W19
NO PARAMETERS
LOAD
UPLOAD impossible.
W20
NOT NOW
The required function is not available at the moment.
W21
CONTROL ON
The required function is inhibited because the drive is running: ENABLE-A and
ENABLE-B are active.
W23
DOWNLOAD VER. KO
Download failed because parameters saved to keypad memory relate to a SW
version or product ID incompatible with the drive SW version or product ID.
W24
VERIFY DATA
Download preliminary operation underway, the system is checking the integrity
and compatibility of the parameters saved in the keypad memory.
W28
OPEN START
Open and close the START signal to start the drive.
W31
ENCODER OK
Encoder tuning procedure finished: the encoder is correctly connected.
W32
OPEN ENABLE
Open and close the ENABLE-A and ENABLE-B signals to enable the drive.
W33
WRITE IMPOSSIBLE
Writing procedure impossible.
W34
ILLEGAL DATA
Illegal value entered, operation failed.
W35
NO WRITE CONTROL
Writing procedure impossible because Control is active and the drive is running.
W36
ILLEGAL ADDRESS
Illegal address entered, operation failed.
W37 ENABLE LOCKED
The drive is disabled and does not acknowledge the ENABLE-A and ENABLE-B
commands because it is writing a Cxxx parameter.
CAUTION: The drive will start up as soon as writing is over!!!
W38 LOCKED
Editing mode cannot be accessed because parameter modification is disabled:
P000 is different from P002.
W39
KEYPAD DISABLED
Editing mode cannot be accessed because the keypad is disabled.
W40
FAN FAULT
Fan locked or disconnected or faulty.
W41
SW VERSION KO
Download impossible because of different SW Versions.
W42
IDP KO
Download impossible because of different IDPs (Identification Products).
W43
PIN KO
Download impossible because of different PINs (Part Identification Numbers).
W44
CURRENT CLASS KO
Download impossible because of different current classes.
W45
VOLTAGE CLASS KO
Download impossible because of different voltage classes.
W46
DOWNLOAD KO
Download impossible (generic cause).
W48
OT Time over
The preset threshold for the drive Operation Time has been exceeded.
W49
ST Time over
The preset threshold for the drive Supply Time has been exceeded.
W50
NTC Fault
NTC sensor for heatsink temperature disconnected or faulty.