SINUS PENTA
PROGRAMMING GUIDE
2/486
REVISION INDEX
Modifications in respect to Programming Guide 15R0102B200, release R.01, SW version 4.11x issued on
11/01/2016.
The following subjects covered in this Programming Guide R.02 (SW version 4.12x) have been added, changed or
suppressed in respect to the previous version R.01 (SW version 4.11x).
Inom current ratings have been increased for models 0030 S12 4T (from 41A to 45A), 0086 S20 4T (from 135A to 145A)
and 0260 S41 4T (from 425A to 445A).
The SVC functionality in the Torque Limit and Frequency Increase Due to Overvoltage – SVC (Smart Voltage Control)
section has been described in a more detailed way.
The MULTITORQUE MENU has been added.
The following parameters have been added to the DIGITAL INPUTS MENU: parameter C154a (ENABLE from Terminal
Board Only); C169a (Speed Regulator Parameter Selection); C179a, C179b (Command and Reference Selection),
C187a, C187b (Multitorque Selection). The figure related to the ENABLE control has been modified.
A new section covering the Torque Follower Mode has been added to the MOTOR CONFIGURATION MENU.
Parameters C011c, C054c, C097c (Torque Follower Mode) have been added.
USER MANUALS MENTIONED IN THIS PROGRAMMING GUIDE
The following User Manuals from Elettronica Santerno are mentioned throughout this Programming Guide:
- 15P0102B1 SINUS PENTA - Installation Guide
- 15Q0102B00 SINUS PENTA – Guide to the Regenerative Application
- 15Q0102B200 SINUS PENTA – Guide to the Synchronous Motor Application
- 15W0102B300 SINUS PENTA Safe Torque Off Function - Application Manual
- 15W0102B500 Motor Drives Accessories – User Manual
- 15G0010B1 PROFIdrive COMMUNICATIONS BOARD – Installation and Programming Guide
- 15G0851B100 DATA LOGGER ES851 – Programming Guide
- 16B0901B1 Remote Drive DRIVE REMOTE CONTROL – User Manual
To Next Page
Loading...
