Santerno Sinus Penta - References Menu

PROGRAMMING GUIDE
SINUS PENTA
61/486
8.5. References Menu
This menu contains the measures of the possible reference sources for speed, torque or PID available in the terminal
board (analog inputs, frequency inputs and encoder input) and sent via serial link or fieldbus.
M037 REF External Analog Reference
M037 Range
Function of the preset type of
reference (voltage/current).
Function of the type of reference (voltage/current) set in P050.
The numerical value always includes two decimal figures; the
unit of measure is V or mA.
Active
Always active.
Address
1687
Function
Measure of the voltage /current value detected by the drive in REF analog input.
M038 AIN1 External Analog Reference
M038 Range
Function of the preset type of
reference (voltage/current)
Function of the type of reference (voltage/current) set in P055.
The numerical value always includes two decimal figures; the
unit of measure is V or mA.
Active
Always active.
Address
1688
Function
Measure of the voltage /current value detected by the drive in AIN1 analog input.
M039 AIN2 External Analog Reference
M039 Range
Function of the preset type of
reference (voltage/current).
Function of the type of reference (voltage/current) set in P060
.
The numerical value always includes two decimals; the unit of
measure is V or mA.
Active
Always active.
Address
1689
Function Measure of the voltage /current value detected by the drive in AIN2 analog input.
M039a XAIN4 External Analog Reference
M039a Range
Function of the preset type of
reference.
Function of the type of reference (voltage) set in P390.
The numerical value always includes two decimals; the
unit of measure is V.
Active
Active only if set via parameter R023.
Address
1729
Function
Measure of the voltage value detected by the drive in XAIN4 analog input.