Santerno Sinus Penta - Page 402

SINUS PENTA
PROGRAMMING GUIDE
402/486
C293 Proportional Multiplier of Derivative and Integral Terms
C293 Range
0 ÷ 1
0: No
1: Yes
Default
0
0: No
Level
ENGINEERING
Address
1293
Function
This parameter defines if the proportional term is used for the multiplication of
the derivative and integral terms as well.
0: No means that the proportional term DOES NOT multiply the integral term.
C294 PID Action
C294 Range
0 ÷ 4
0: External output
1: Reference
2: Reference sum
3: Voltage sum
4: Full Ref. Sum
Default
1
1: Reference
Level
ENGINEERING
Address
1294