SINUS PENTA
PROGRAMMING GUIDE
444/486
R051 DST Start HHMM – Hour/Minutes
Active
This parameter can be viewed and changed only if the Data Logger ES851 is
installed and activated (R021 = ENABLE).
Address
525
Function
The first digit or the first two digits (if the total digits are 3 or 4 respectively)
correspond to the start hours. The last two digits correspond to the minutes
Example:
200 = 2h 00m
2400 = 0h 0m (midnight between the day set in R050 and the previous day.)
R052 DST End WDMM – Week/Day/Month
Active
This parameter can be viewed and changed only if the Data Logger ES851
is installed and activated (R021 = ENABLE).
Address
526
Function
If the first digit of the parameter is lower than 6:
The first digit (W) indicates the week of the month when the DST ends (1 =
first week, 2 = second week, 3 = third week, 4 = fourth week, 5 = last week).
The second digit (D) indicates the
day of the week (1 = Monday, 7 =
Sunday).
The third and fourth digits (MM) indicate the start month (01 = January, 12 =
December).
Example:
European Union: 5710 (last Sunday in October)
USA: 1711 (first Sunday in November)
Brazil: 3702 (third Sunday in February)
If the first digit of the parameter is higher than or equal to 6:
The first two digits (WD) correspond to the day of the
starts, added to 60 (61 corresponds to 1, 91 corresponds to 31).
The third and fourth digit (MM) indicate th
e start month (01 corresponds to
January, 12 corresponds to December).
Example:
R053 DST End HHMM – Hour/Minutes
Active
This parameter can be viewed and changed only if the Data Logger ES851 is
installed and activated (R021 = ENABLE).
Address
527
Function
The first digit or the first two digits (if the total digits are 3 or 4 respectively)
correspond to the end hours. The last two digits correspond to the minut
Example:
200 = 2h 00m
2400 = 0h 0m (midnight between the day set in R052 and the previous day.)
To Next Page
Loading...
