PROGRAMMING GUIDE
SINUS PENTA
49/486
If an alarm trips, find the cause responsible for the alarm and reset the drive. Enable input
MDI3 (terminal 16) for some time, or press the RESET key on the display/keypad.
NOTE
The ENABLE-A and ENABLE-B inputs are allocated to the STO function. If this safety
functionality is to be adopted, the control mode and the control circ
uit of these signals must
be accomplished as per the Safe Torque Off Function - Application Manual.
That manual also includes a detailed validation procedure of the control configuration of the
STO function to be executed upon first start-up and also periodically at yearly intervals.
To Next Page
Loading...
