RM0033 Rev 9 1099/1381
RM0033 USB on-the-go high-speed (OTG_HS)
1260
30.2.1 General features
The OTG_HS interface main features are the following:
• It is USB-IF certified in compliance with the Universal Serial Bus Revision 2.0
Specification
• It supports 3 PHY interfaces
– An on-chip full-speed PHY
– An ULPI interface for external high-speed PHY.
• It supports the host negotiation protocol (HNP) and the session request protocol (SRP)
• It allows the host to turn V
BUS
off to save power in OTG applications, with no need for
external components
• It allows to monitor V
BUS
levels using internal comparators
• It supports dynamic host-peripheral role switching
• It is software-configurable to operate as:
– An SRP-capable USB HS/FS peripheral (B-device)
– An SRP-capable USB HS/FS/low-speed host (A-device)
– An USB OTG FS dual-role device
• It supports HS/FS SOFs as well as low-speed (LS) keep-alive tokens with:
– SOF pulse PAD output capability
– SOF pulse internal connection to timer 2 (TIM2)
– Configurable framing period
– Configurable end-of-frame interrupt
• It embeds an internal DMA with shareholding support and software selectable AHB
burst type in DMA mode
• It has power saving features such as system clock stop during USB suspend, switching
off of the digital core internal clock domains, PHY and DFIFO power management
• It features a dedicated 4-Kbyte data RAM with advanced FIFO management:
– The memory partition can be configured into different FIFOs to allow flexible and
efficient use of RAM
– Each FIFO can contain multiple packets
– Memory allocation is performed dynamically
– The FIFO size can be configured to values that are not powers of 2 to allow the
use of contiguous memory locations
• It ensures a maximum USB bandwidth of up to one frame without application
intervention
To Next Page
Loading...
Need help?
General
