Memory and bus architecture RM0033
60/1381 RM0033 Rev 9
Embedded bootloader
The embedded bootloader mode is used to reprogram the Flash memory using one of the
following serial interfaces:
• USART1(PA9/PA10)
• USART3(PB10/11 and PC10/11)
• CAN2(PB5/13)
• USB OTG FS(PA11/12) in Device mode (DFU: device firmware upgrade).
The USART peripherals operate at the internal 16 MHz oscillator (HSI) frequency, while the
CAN and USB OTG FS require an external clock (HSE) multiple of 1 MHz (ranging from 4 to
26 MHz).
The embedded bootloader code is located in system memory. It is programmed by ST
during production. For additional information, refer to application note AN2606.
To Next Page
Loading...
