EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #204 background imageLoading...
Page #204 background image
204 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
set ptp
Use this command to provision the PTP port’s common provisioned attributes,
multicast-specific attributes, and unicast-specific attributes.
Common Provisioned Attributes:
PTP Profile, Management Addressing mode (Multicast/Unicast), Two-step Clock
mode, Alternate Master flag, IP Header Time to Live (TTL) field, Timescale, PTP
state, Clock ID, Priority 1, Priority 2, Domain, Diffserv State, Diffserv Code Point,
Dither, Maximum clients, Announce limit, Synchronization limit, Delay limit. See
Figure 4-10, Figure 4-11, and Figure 4-12 for diagrams of the hierarchy for the PTP-
Common commands.
See Table 4-10 for descriptions of the common provisioned attributes.
Multicast Specific Attributes:
Announce Message Timeout, Client Timeout, VLAN ID, Sync Message Interval,
Announce Message Interval, Delay Interval. See Figure 4-13 for a diagram of the
hierchy for the PTP Multicast commands.
See Table 4-11 for descriptions of the attributes specific to Multicast.
Unicast Specific Attributes – Non-Fixed:
Unicast Negotiation state, Dynamic Lease Interval. See Figure 4-14 for a diagram of
the hierchy for the PTP Unicast – Non-Fixed commands.
See Table 4-12 for descriptions of the attributes specific to Unicast – Non-Fixed.
Unicast Specific Attributes - Static:
Unicast IP addresses (up to 10), Unicast State, Unicast Clock ID, VLAN ID, Sync
Message Interval, Announce Message Interval, Delay Interval. See Figure 4-15 for
a diagram of the hierchy for the Unicast - Static commands.
See Table 4-13 for descriptions of the attributes specific to Unicast -Static.
Expansion Shelf-Specific Attributes:
State, Timescale, Two-step Clock mode, Alternate-Master, Priority 1, Priority 2,
Domain, Dither, and Clock ID
Command Syntax:
Common Attributes:
To provision the PTP profile for the grandmaster:
Note: This is a special mode which allows the TP5000 user to
pre-allocate service for up to designated 10 clients, rather than using
dynamic unicast negotiation of leases.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals