Terex MHL360 E - Page 279

CARE AND MAINTENANCE 7
MHL360 E 7.59
7.7.14.1 Check hydraulic oil level
h Chapter 7.4.4 Check hydraulic oil level
7.7.14.2 Changing hydraulic oil
ATTENTION
Change the hydraulic oil at operating tempera-
ture.
►
Retract all hydraulic cylinders.
►
Switch off the diesel engine.
►
Unscrew the ventilation filter (311/1).
►
Place suitable oil drip pans below the en-
gine.
j WARNING
Burns due to hot fluids and sur-
faces
• Hot oil can cause burns if it
comes into contact with the skin
or eyes. Wear suitable protective
clothing and safety goggles
In an emergency: Administer first
aid, seek treatment from a doctor
►
Loosen the cap (310/1) on the drain valve
of the hydraulic tank and drain the oil into
clean containers.
ATTENTION
Collect old oil with a suitable reser-
voir. Do not allow them to seep into
the ground or water! Give to an au-
thorized waste disposal company to
dispose of in an environmentally-
friendly manner.
►
Close the sealing cap on the drain valve
carefully.
j WARNING
Danger of injury due to falling
• Before topping up the hydraulic
oil, make sure that suitable
equipment for this purpose (e.g. a
pedestal) is at hand.
In an emergency: Administer first
aid, seek treatment from a doctor
BSB50039
1
Fig. 310 Drain valve
BSB50040
1
32
Fig. 311 Ventilation and return filter