Toa VX-2000SF - Page 169

Chapter 7: PC SOFTWARE OFFLINE SETTINGS
10. ACTIVATION SETTING MODE
7-54
No function is set for the key.None
Stops only base pattern broadcasts.Base Pattern End
Broadcasts are pre-selected for zones selected here.Zone Selection
Broadcasts are pre-selected for all zones.All
Cancels pre-selections.Clear
Accesses the general-purpose EV messages.General EV
The internal chime can be assigned to specific messages and broadcasts. Chime
Press when making announcements from the microphone.
Notes
•TheoperationoftheTalkkeycanbesettoeitherofthefollowing2types:
PTT: Broadcasts can be made as long as the switch is pressed.
Lock: Pressing the switch turns on the microphone and permits broadcasts.
The microphone turns off when the switch is pressed again.
The timer can be set for 1 – 20 minutes in 1-minute step to
automatically turn off the microphone if the user forgets to turn it off.
The timer function can be disabled by selecting "Infinity".
•Pre-announcement chime and post-announcement chime can also be
enabled or disabled with these settings.
Talk
Activates the control output set in the [Pattern Settings].Control Output Interlock
Makes broadcasts with the base pattern set in the [Pattern Settings].Base Pattern Change
Selects a single zone to be monitored with the Remote Microphone's monitor
speaker.
Audio Monitor
Clears the failure status and exits the failure indication mode.
(Extinguishing the failure indicator lamp and stopping the buzzer.)
Failure Output Reset
[When "General" type is set for the Remote Microphone]
(For general-pu
rpose broadcasts only)
Only functions that are related to emergency activation can be set. Enters
emergency mode.
The patterns set in [Emergency Settings] can also be recalled and broadcast.
[When "Emergency" type is set for the Remote Microphone]
(For both emergency and general-purpose broadcasts)
•EmergencyActivation: Enters emergency mode. Patterns set in the
[Emergency Settings] window can also be recalled
and broadcast.
•EmergencyAlert: Recallsthealertmessage.
•EmergencyEvacuation: Recallstheevacuationmessage.
•EmergencyReset: Restorestheemergencymodetonormalmode.
The reset message can also be recalled.
•Silence: TheEVmessagestops.
Emergency
Pressing the key after confirming the failure symptoms stops a buzzer and
changes the failure indicator light to steady-on.
(When a failure corresponding to the pattern created in the [Failure Output
Pattern Settings] occurs, the failure indicator flashes, and a buzzer is sounded.)
Failure Output Receipt
Change the sound volume for the volume pattern set in the [Pattern Settings].
The volume level changes by 3 dB each time the key is pressed.
Volume Up/Down
Step 4. Select the key to which a function is to be assigned.
The function key name can also be changed. Select a line to rename, then click on it again, and the
name can be changed.
Step 5. Select the function.
[Description of assignable functions]