Chapter 5: OPERATION
2. EMERGENCY BROADCASTS
5-14
(1) From Emergency Mode Activation to Reset
Described below are the steps of system operation from emergency mode activation to reset.
Step 1. Activate emergency broadcast mode.
Press the Emergency Activation button
.
•Emergency mode is activated and the Emergency
Activation button lights red.
•The pre-configured emergency sequence pattern is
recalled, and the Alert EV Message is broadcast to all
zones.
•Because the alert message is set for broadcast to all
zones, the Select LED lights green.
Step 2. Press the Evacuation EV key
to broadcast the Evacuation
EV message, if necessary.
2-1. Broadcasting EV messages to the entire zone.
When the emergency mode is activated, all zones are
automatically pre-selected. The Evacuation EV message
will be broadcast to all zones, and the EV Broadcast LED
lights green.
Emergency Activation button
4
All-Zone Call key
Select LED
Unused
Lights
2
Evacuation EV key
EV Broadcast LED
EV Enable LED
Lights
Continued on next page
To Next Page
Loading...
