Cisco ASR 1004 Hardware Installation Guide

CHAPTER 5
Preparing Your Site for Installation
This chapter contains important safety information you should know before working with the Cisco ASR
1000 Series Aggregation Services Routers and guides you through the process of preparing your site for
router installation.
This chapter contains the following sections:
•
Prerequisites and Preparation , page 111
•
Safety Guidelines , page 112
•
Compliance Requirements, page 113
•
Cautions and Regulatory Compliance Statements for NEBS , page 114
•
Standard Warning Statements, page 115
•
Site Planning, page 118
•
Preventing Electrostatic Discharge Damage, page 130
•
Electrical Safety, page 131
•
Receiving the Cisco ASR 1000 Series Router, page 132
•
Chassis-Lifting Guidelines, page 133
•
Tools and Equipment, page 134
•
Checking the Shipping Container Contents, page 135
•
Cisco ASR 1000 Series Router Installation Checklist, page 136
Prerequisites and Preparation
Before you perform any of the procedures in this guide, we recommend that you:
•
Read the safety guidelines in the next section and review the electrical safety and ESD-prevention
guidelines in this guide.
•
Ensure that you have all of the necessary tools and equipment (see Tools and Equipment, on page 134).
Cisco ASR 1000 Series Router Hardware Installation Guide
111

Cisco ASR 1004 Specifications

General

Product Type	Router
Form Factor	Rack-mountable
Rack Height	2U
Forwarding Capacity	Up to 20 Gbps
Total Number of Ports	Varies by configuration
Number of Total Expansion Slots	4
Product Series	ASR 1000
Model	ASR 1004
Forwarding Performance	Up to 20 Gbps
Operating System	Cisco IOS XE
Power Supply	Dual
Route Processor	ASR 1000 Series Route Processor
Network Interface Modules	SFP, SFP+, Gigabit Ethernet, 10 Gigabit Ethernet
Interfaces/Ports	Varies by configuration
Expansion Slot Type	SPA
Throughput	20 Gbps
Redundancy	Power supply, Route Processor
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, SFP, SFP+
Storage	Up to 64 GB Flash